Cold Cylinder Cutout
During a cold start or extended periods at low idle, the engine ECM will automatically turn off one unit injector at a time in order to determine if the cylinder is firing. If the ECM determines that the cylinder is not firing, the ECM turns off the unit injector. If the ECM determines that the cylinder is firing, the ECM turns on the unit injector. This strategy improves engine starting. This strategy reduces the following: white smoke, the use of ether injection and warm-up time.
Cold Mode Operation
Cold mode controls fuel injection timing when the engine is cold. When the engine is cold, controlling the fuel injection timing reduces the possibility of engine damage. When the engine is cold, controlling the fuel injection timing helps minimize white smoke.
Cold mode is activated whenever the engine coolant temperature is below 70 °C (158 °F). Cold mode remains active until the engine coolant temperature is warmer than 73 °C (163 °F).
FRC Limit
The flash file inside the engine ECM sets certain limits on the amount of fuel that can be injected. The FRC limit is a limit that is based on the boost pressure. The boost pressure is calculated as the difference in pressure between atmospheric pressure and turbocharger outlet pressure. The FRC limit is used to control the air/fuel ratio for control of emissions. When the engine ECM senses a higher boost pressure, the engine ECM increases the FRC limit. A higher boost pressure indicates that there is more air in the cylinder. When the engine ECM increases the FRC limit, the engine ECM allows more fuel into the cylinder.